Manual
Table Of Contents
- Support for QSIG Over BRI and Q.931 Over BRI Backhaul
- Feature Overview
- Supported Platforms
- Supported Standards, MIBs, and RFCs
- Prerequisites for Using This Feature
- Configuration Tasks
- Provisioning Tasks
- Monitoring and Maintaining the Feature
- Configuration Examples
- Provisioning Examples
- Command Reference
- Reference Information
- Obtaining Documentation
- Documentation Feedback
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Glossary
Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Provisioning Tasks
14
Cisco MGC Software Release 9.5(2)
Adding MGCP Signaling Services
To add MGCP signaling services to your provisioning data, perform the following steps:
Step 1 If you do not already have an active provisioning session, start one as described in the “Starting a
Provisioning Session” section on page 9.
Step 2 Enter the following command to add a MGCP signaling service:
mml>prov-add:mgcppath:name="name", desc="description", extnode=”mgw”