Manual

Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Provisioning Tasks
15
Cisco MGC Software Release 9.5(2)
Where:
• name—The name you want to give to the MGCP signaling service. The name can be as many as 20
characters long and can contain numbers, letters, and the dash (-) symbol. The name should begin
with a letter.
• description—An assigned name. It can be as many as 128 alphanumeric characters in length.
• mgw—MML name of a previously defined voice gateway external node.
For example, to add an MGCP signaling service named mgcpsvc1, you would enter the following
command:
mml>prov-add:mgcppath:name="mgcpsvc1",extnode="bri-3640-01",desc="MGCP service to C2600"
Step 3 If there are no other components that you need to provision, end your provisioning session as described
in the “Saving and Activating Your Provisioning Changes” section on page 10.
If you need to modify the settings of the properties for your MGCP signaling service, perform the
procedure in the “Modifying MGCP Signaling Service Properties” section on page 22 and return here.
Otherwise, proceed to the “Adding QSIG/Q.931 Over BRI Backhaul Signaling Services” section on
page 15.
Adding QSIG/Q.931 Over BRI Backhaul Signaling Services
To add QSIG/Q.931 over BRI Backhaul signaling services to your provisioning data, perform the
following steps:
Step 1 If you do not already have an active provisioning session, start one as described in the “Starting a
Provisioning Session” section on page 9.
Step 2 Enter the following command to add an QSIG/Q.931 over BRI Backhaul signaling service:
mml>prov-add:bripath:name="name", desc="description", extnode=”mgw”, mdo=variant,
side=qside, custgrpid=”idnum”, crlen=”callref”
Where:
• name—The name you want to give to the QSIG/Q.931 over BRI Backhaul signaling service. The
name can be as many as 20 characters long and can contain numbers, letters, and the dash (-) symbol.
The name should begin with a letter.
• description—An assigned name. It can be as many as 128 alphanumeric characters in length.
• mgw—MML name of a previously defined QSIG/Q.931 BRI voice gateway external node.
• variant—MDO filename, from the following list:
– ETS_300_102
– Q931
– ETS_300_172
• qside—Q.931 call model side, user for user side and network for network side; (network).
• idnum—VNET ID, a four-digit ID; (0000).
• callref—Call reference length; Valid values: 0 through 2. The value indicates the number of bytes
in the call reference length (0).