Manual

Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Provisioning Tasks
20
Cisco MGC Software Release 9.5(2)
Note This parameter must be set to 0 for QSIG/Q.931 over BRI Backhaul D-channels when the
associated external node is a Cisco 17xx.
• sport—Physical port of the associated slot on the Cisco BRI voice gateway. Valid values are 0 and
1. Default value is 0.
• sunit—Used only for QSIG/Q.931 over BRI Backhaul D-Channels. Valid values are 0 and 1. Default
value is 0.
For example, to add an QSIG/Q.931 over BRI Backhaul D-channel named bridchan1, enter the following
command:
mml>prov-add:dchan:NAME="bridchan1",DESC="QSIG BRI D channel 1", SVC="BRI", PRI="1",
TCPLINK="britcp1", sigslot="4", sigport="1", subunit="1"
Note The parameters listed above are those required for the creation of a D channel for an
QSIG/Q.931 over BRI Backhaul signaling service. For a complete list of parameters for this
component, refer to the “D-Channel” section on page 45.
Step 3 If there are no other components that you need to provision, end your provisioning session as described
in the “Saving and Activating Your Provisioning Changes” section on page 10.
Modifying QSIG/Q.931 Over BRI Backhaul Components
The following sections contain the procedures for modifying the QSIG/Q.931 over BRI Backhaul
connection in your Cisco MGC provisioning data:
• Modifying Cisco BRI Voice Gateway External Nodes, page 20
• Modifying QSIG/Q.931 Over BRI Backhaul Signaling Services, page 21
• Modifying MGCP Signaling Service Properties, page 22
• Modifying IP Routes, page 23
• Modifying Backhaul TCP Links, page 24
• Modifying MGCP IP Links, page 24
• Modifying QSIG/Q.931 Over BRI Backhaul D-Channels, page 25
Modifying Cisco BRI Voice Gateway External Nodes
DESC is the only parameter that can be modified for an existing Cisco BRI voice gateway external node.
To edit the description of a Cisco BRI voice gateway external node, perform the following steps:
Step 1 Start a provisioning session as described in the “Starting a Provisioning Session” section on page 9.
Step 2 Enter the following command to edit the description of a Cisco BRI voice gateway external node:
mml>prov-ed:extnode:name="name", desc="description"
Where:
• name—MML name of the Cisco BRI voice gateway external node to be modified.