Manual
Table Of Contents
- Support for QSIG Over BRI and Q.931 Over BRI Backhaul
- Feature Overview
- Supported Platforms
- Supported Standards, MIBs, and RFCs
- Prerequisites for Using This Feature
- Configuration Tasks
- Provisioning Tasks
- Monitoring and Maintaining the Feature
- Configuration Examples
- Provisioning Examples
- Command Reference
- Reference Information
- Obtaining Documentation
- Documentation Feedback
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Glossary
Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Reference Information
41
Cisco MGC Software Release 9.5(2)
RTRV-IPLNK—Display Primary and Secondary States of an IP Link
This command has been modified for the inclusion of service state data for Backhaul TCP links in the
command response.
SET-DCHAN—Change Service State of a D-Channel
This command has been modified for the inclusion of QSIG/Q.931 Over BRI Backhaul D-channels in
the command.
SET-DEST—Change Service State of a Destination
This command has been modified for the inclusion of QSIG/Q.931 Over BRI Backhaul signaling
services in the command.
Reference Information
The following sections contain reference material related to this feature. Information is included on the
following areas:
• XECfgParm.dat Parameters, page 41
• Alarms, page 42
• Components, page 42
• External Node Types, page 49
• Provisioning Worksheets, page 51
XECfgParm.dat Parameters
The XECfgParm.dat file configuration parameters added for this feature are in the table below. For
information on the other XECfgParm.dat parameters, refer to the Cisco Media Gateway Controller
Software Release 9 Installation and Configuration Guide.