Manual
Table Of Contents
- Support for QSIG Over BRI and Q.931 Over BRI Backhaul
- Feature Overview
- Supported Platforms
- Supported Standards, MIBs, and RFCs
- Prerequisites for Using This Feature
- Configuration Tasks
- Provisioning Tasks
- Monitoring and Maintaining the Feature
- Configuration Examples
- Provisioning Examples
- Command Reference
- Reference Information
- Obtaining Documentation
- Documentation Feedback
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Glossary
Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Reference Information
43
Cisco MGC Software Release 9.5(2)
New Components
The following provisioning components are added for this feature.
Backhaul TCP Link
The Backhaul TCP link component represents a static IP route. Its MML name is as follows:
• MML Name—TCPLINK
The Backhaul TCP link component structure is shown in Table 4.
The following attributes cannot be modified:
• NAME
• EXTNODE
The following rules apply when you are creating or editing QSIG/Q.931 Over BRI Backhaul signaling
services:
• You must define the TYPE parameter as PRI. If the TYPE parameter is not defined as PRI when the
TCPLINK is added/edited, a warning is issued. If the TYPE parameter is not defined as PRI when
the provisioning session is copied or deployed, an error message is generated and the copy or
deployment is stopped.
• You must define the TCPLINK parameter with the same EXTNODE attribute that its associated
BRIPATH has. If the TCPLNK is not defined when the BRIPATH is added/edited, a warning is
issued. If the TCPLINK is not defined when the provisioning session is copied or deployed, an error
message is generated and the copy or deployment is stopped.
Table 4 TCPLINK Component Structure
Parameter MML
Name Parameter Description Parameter Value (Default)
NAME Unique component
name used in MML
commands
The name can be as many as 20 alphanumeric
characters. No special characters other than “-” are
allowed. The name should begin with a letter.
DESC Component description The description can be up to 128 characters.
TYPE Signaling service type Identifies the type of signaling service associated
with this link. Must be set to BRI.
IPADDR Local IP address IP_Addr1, IP_Addr2, IP_Addr3, or IP_Addr4.
PORT Port number 1024 through 65535; (2428).
PEERADDR Highest priority
destination address
IP address in dotted decimal notation.
PEERPORT Destination port number 1024 through 65535; (2428).
EXTNODE MML name for
associated external node
MML name of a previously provisioned Cisco BRI
voice gateway.
IPROUTE MML name for first IP
route (optional)
MML name of a previously provisioned IP route.