Manual

Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Reference Information
47
Cisco MGC Software Release 9.5(2)
*.ANationalPrefix Determines the prefix of the outgoing calling number when NOA = National.
Value range: NULL or a numeric string.
Default = NULL
*.AuditWhenSscIs Specifies if the MGC (the engine) will perform an audit on the endpoints of the
gateway associated with this cxnSigPath when the MGC receives an In Service
(IS) Service State Change (SSC) message. For smaller gateways (AS5300) set
value = True, the audit is performed when the connection becomes available; for
larger gateways (MGX8260, VISM) set value = False. This property value is
dynamically editable using MML commands. Values are: TRUE (1) or FALSE
(0).
Default: False
*BDigitCCPrefix Controls functionality that applies a country code prefix to the called party
number before sending the call forward.
Values are: 0 (disabled) or 1 (enabled).
Default: 0
*BDigitCCrm Provides a country code digit string to which the called party Number leading
digits can be compared, and if matched have those digits removed from the front
of the number. This modification is made before sending the call forward. Values
are: NULL (default) or null, or a maximum 5-digit string.
*.BInternationalPrefix Determines the prefix of the outgoing called number when NOA = International.
Value range: NULL or a numeric string.
Default = NULL
*.BNationalPrefix Determines the prefix of the outgoing called number when NOA = National.
Value range: NULL or a numeric string.
Default = NULL
*.CCOrigin Provides against the origin trunk group of a call the country code digits, which if
needed can be prefixed on a number before sending the call forward. Only
required when the property domain is SigPath or LinkSet. Values: NULL or a
maximum 5-digit string.
Default: NULL
*.CompressionType Compression type. Indicates the G.711 compression type used on the trunk.
Values are: 0 (none), 1 (mu-law), 2 (A-law), or 3 (clear channel).
Default: 1
*.GatewayName Used to identify the Gateway in the CDR record, that is whatever this value is set
to will be placed in the CDR.
Default: N/A
*.GWDefaultCodecString Enables the IOCC-MGCP to send the ordered series of codec choices separated
by semicolons. Refer to your gateway documentation for a list of supported
codec names. The following values represent some of the more common codec
names.
Values: NULL, G.711a, G.711u, G.729, G.729a, and G.729b
Default: NULL
Table 7 MGCP Properties (continued)
Property Definition