Manual
Table Of Contents
- Support for QSIG Over BRI and Q.931 Over BRI Backhaul
- Feature Overview
- Supported Platforms
- Supported Standards, MIBs, and RFCs
- Prerequisites for Using This Feature
- Configuration Tasks
- Provisioning Tasks
- Monitoring and Maintaining the Feature
- Configuration Examples
- Provisioning Examples
- Command Reference
- Reference Information
- Obtaining Documentation
- Documentation Feedback
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
- Glossary
Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Reference Information
48
Cisco MGC Software Release 9.5(2)
*.GWNetworkContinuity This property enables or disables the network continuity test on the VISM.
Values: 0 or 1.
Default: 0
*.GWProtocolVersion The MGCP protocol version to use when communicating with the gateway.
Default: MGCP 0.1
*.InitEndpointsAsEnabled Specifies if the MGC (the engine) initializes its endpoint objects (corresponding
to those on the gateway) as enabled or disabled. For gateways that send RSIP
messages at initialization to inform MGC of their endpoint state, set to False; all
others set to True. This property value is dynamically editable using MML
commands.
Values: TRUE (1) or FALSE (0)
Default: True
*.MgcpBehavior Regulates the MGC engine behavior to allow different MGCP gateway types to
return different codes for the same error. Value range: 0 through 3.
• 0—No action
• 1—Resolves a connection conflict between the MGC and a media gateway
to allow a circuit to be used after a CRCX failure (return code 501) by
clearing the call; VISM and MX8260
• 2 or 3—Resolves a connection conflict between the MGC and a media
gateway to allow a circuit to be used after a CRCX failure (return code 502)
by forcing a delete and reconnection; 5300
Default: 0
Note Additional differences can be handled by adding enumerated values.
*.mgcpDomainNameRemote Default MGCP remote domain name. It is used to append to the audit command
to send to the remote gateway.
Default: remote@name.net
*.mgcpGWStdbyHeartbeatInterval This interval time, in seconds, enables the MGC to send the standby heartbeat to
complete a health check on the remote gateway. Value range: 0 to 30 seconds.
Default value: 30 seconds
*.mgcpHeartbeatInterval Indicates how often the MGCP protocol should heartbeat the gateway. Value
range: 0 through 1000.
Default: 10
Note To prevent MGCP IP links from flapping, set this to a minimum value of
4 when the Cisco MGC call agent is working with a Cisco MGX-8260.
Table 7 MGCP Properties (continued)
Property Definition