Manual

Support for QSIG Over BRI and Q.931 Over BRI Backhaul
Supported Standards, MIBs, and RFCs
5
Cisco MGC Software Release 9.5(2)
Supported Standards, MIBs, and RFCs
Standards
No standards are associated with this feature.
MIBs
No new or modified MIBs are supported by this feature. Existing MIBs are used to support this feature.
For more information on the MIBs used in the Cisco MGC software, refer to the Cisco Media Gateway
Controller Release 9 Management Information Base Guide.
RFCs
No RFCs are associated with this feature.
Prerequisites for Using This Feature
You must have Cisco MGC software Release 9.5(2). Prerequisites for this release can be found in the
Release Notes for the Cisco Media Gateway Controller Software Release 9.5(2).
The Support for ISDN BRI over TCP IOS feature module contains information on the prerequisites for
the implementation of this feature for Cisco media gateways.
Configuration Tasks
Implementation of this feature does not require modification of the associated XECfgParm.dat
parameters. Modification of the default values for these parameters is required only in response to
troubleshooting problems.
Provisioning Tasks
The following sections describe the provisioning tasks related to this feature:
• Provisioning Prerequisites, page 5
• Provisioning Procedures, page 8
• Troubleshooting Provisioning Data, page 30
Provisioning Prerequisites
This section lists the data that you must gather to successfully provision this feature. For more
information on planning the provisioning for the rest of the Cisco MGC software, refer to the Cisco
Media Gateway Controller Software Release 9 Provisioning Guide.