Release Notes

11
Cisco Prime Network 4.1 Release Notes
OL-31014-01
Prime Network 4.1 Bugs
Auto-Discovery of Unsupported Modules
Auto-discovery of unsupported module types is done on a best effort basis and is based on standard
information which is reported by the device as part of the ENTITY-MIB. Operators are advised to
validate that the discovery was fully successful. If not, add support for the specific module type using
the VCB.
SNMP Configuration
When VNE is configured to use SNMPv2 or SNMPv3 for discovery, ensure that the device must be
enabled with SNMPv1 also.
StarOS 14.0 - Disabled MIBs
Starting from StarOS 14.0, the following MIBs are disabled by default in the device.
• ENTITY-MIB
• IF-MIB
• ENTITY-STATE-MIB
• CISCO-ENTITY-FRU-CONTROL-MIB
The physical inventory will not be modeled if these MIBs are disabled. Enable the MIBs using the
following:
configure
snmp mib ENTITY-MIB
snmp mib IF-MIB
snmp mib ENTITY-STATE-MIB
snmp mib CISCO-ENTITY-FRU-CONTROL-MIB
To verify if the above MIBs are enabled, use:
show snmp server
Prime Network 4.1 Bugs
This section contains the following information:
• Open Bugs, page 11
• Resolved Bugs, page 20
• Closed Bugs, page 24
• Bugs Resolved in Earlier Releases but Still Open in Prime Network 4.1, page 26
• Using the Bug Search Tool, page 26
Open Bugs
The following sections identify bugs that are open in Prime Network 4.1, according to the following
criteria:
• All catastrophic and severe bugs (if any).
• Customer-found bugs.
• Moderate, minor, and enhancement bugs that are considered likely to affect the customer’s
experience with Prime Network 4.1.