Release Notes

10 Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0
Release Notes
Problem: When configuring a manual IPv6 tunnel with EUI-64 format, the Global
IPv6 address is not created. (CQ140132)
Solution: Do not use the EUI-64 format when configuring an IPv6 manual tunnel.
Problem: You cannot configure ipv6 tunnel parameters if you previously did not
define the mode type. (CQ140919)
Solution: Configure the tunnel mode first when configuring an IPv6 tunnel.
Problem: You cannot run ping or traceroute by using a Domain Name on the web-
based interface. (CQ143759)
Solution: Use the command line interface instead.
Problem: When you are prompted to modify your password at the initial log in,
and then change the default password to use some special strings, the user will fail
to log in again with the modified password. An example of special strings would be:
like "Cisco100%+" or "WERab#%56". (CQ145271)
Solution: Use other passwords without special strings or use these strings as a
password after changing the password at least one time.
Problem: It is impossible to configure more than 255 multicast groups on an
Sx500 switch in Router Mode. The stated limit in the documentation is 1k multicast
groups. (CQ143282)
Solution: There is no workaround.
Problem: There is a problem using PoE auto control via time-range. After
performing a save and reboot, the saved time-range configuration on port 4 is also
displayed on port 5 and 6. (CQ146121)
Solution: There is no workaround.
Problem: If you modify an IPv6 tunnel configuration, the change will not take
effect until you perform a shut then no shut on the tunnel interface. (CQ146071)
Solution: You must per form a shut then no shut the tunnel interface for it to take
effect.
Problem: The power inline server time-range function does not work.
(CQ146048)
Solution: Use the power inline auto time-range function instead, but you will need
to use an opposite time-range.