Release Notes

8 Rel Notes for SF250, SG250, SF350, SG350, SG350X, SG350XG, SF550X, SG550X, and SG550XG Series Switches, 2.2.5.68
Release Notes
Open Bugs in Software Version 2.1.0
This section lists that bugs that are acknowledged in software version 2.2.5.68:
CSCuz45730 Symptom: When negotiating 60W PoE with Cisco PD
switches, Cisco PoE-PSE switches sometimes are not able to
provide 60W and provide 30W only.
Workaround: Connect PD switch to PSE switch before PSE
switch boot up. Or disconnect then connect PD switch when
issue happens. Or use static 60 watt.
Table 4 Open Bugs in Software Version 2.1.0
Bug ID Description
CSCux77651 Symptom: When applying policer on ingress interface and
sending traffic with multiple priority may result in dropping of
higher priority traffic on lower speed egress ports.
Workaround: There is no workaround.
CSCux89413 Symptom: Auto SmartMacro—In some cases, the interface
is set to BPDU guard erri-disable state after replacing the
device connected to the interface from a phone/desktop to
switch.
Workaround: Either disable persistent setting on the
interface, or, after the issue occurs, remove the desktop/phone
macro from the interface, reactivate the port, and then connect
the switch to the interface.
CSCux89418 Symptom: When connecting Sx350P as PD to Sx300P/
Sx500P as PSE, Sx350P reboots when disconnecting AC
power. After rebooting, Sx350P powers up and functions as
expected.
Workaround: There is no workaround.
Table 3 Open Bugs in Software Version 2.2.0.63 (Continued)
Bug ID Description