Installation Guide
Table Of Contents
- Cisco USB BLE Beacon Installation Guide
- Contents
- Preface
- Overview of Cisco USB BLE Beacon
- Installation and Initial Setup
- Prerequisites for Cisco USB BLE Beacon Installation
- Supported Hardware
- Installation Guidelines
- Installing the Cisco USB BLE Beacon
- Importing Maps from Cisco Prime Infrastructure
- Managing Cisco CMX for Cisco USB BLE Beacon Configurations
- Establishing the Connection Between Cisco CMX and Cisco DNA Spaces BLE Manager
- Configuring a Cisco USB BLE Beacon Profile
- Technical Specifications
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco USB BLE Beacon in Japan
- Canadian Compliance Statement
- Industry Canada
- This Device Meets FCC and International Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Declaration of Conformity Statements
Guidelines for Operating Cisco USB BLE Beacon in Japan
This section provides guidelines for avoiding interference when operating Cisco USB BLE Beacon in Japan.
These guidelines are provided in both Japanese and English.
Japanese Translation
English Translation
This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such
as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and
unlicensed specified low-power radio stations) used in factory production lines.
1. Before using this equipment, make sure that no premises radio stations or specified low-power radio
stations of RF-ID are used in the vicinity.
2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the
frequency or stop using the device; contact the number below and ask for recommendations on avoiding
radio interference, such as setting partitions.
3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the
number below.
Contact Number: 03-6434-6500
Canadian Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Cisco USB BLE Beacon Installation Guide
13
Declarations of Conformity and Regulatory Information
Guidelines for Operating Cisco USB BLE Beacon in Japan