Specifications

5-31
Cisco Content Services Switch Getting Started Guide
OL-6711-01
Chapter 5 Where to Go Next
Comprehensive CSS Documentation List
Chapter 6, Configuring
the Internet Protocol
• Internet Protocol (IP) configuration quick start.
• Configuring an IP route. You can configure a static route, a default
static IP route, a blackhole route (where the CSS drops any packets
addressed to the route), or a firewall IP route.
• Disabling an implicit service for the static route next hop, to forward
traffic to the next hop even when the next hop is unavailable.
• Configuring an IP source route to enable the CSS to process frames
with information that overrides the default routing.
• Configuring the IP record route to enable the CSS to process frames
with the IP address of each router along a path.
• Configuring box-to-box redundancy between two identically
configured CSSs.
• Configuring IP equal-cost multipath (ECMP) selection algorithm and
the preferred reverse egress path.
• Forwarding IP subnet broadcast addressed frames.
• Configuring IP unconditional bridging to always make a bridging
decision on the received packets.
• Configuring IP opportunistic Layer 3 forwarding to enable
opportunistic Layer 3 forwarding and allow the CSS to make Layer 3
forwarding decisions even if the Layer 2 packet destination MAC
address does not belong to the CSS.
• Displaying IP configuration information.
Table 5-3 Cisco Content Services Switch Routing and Bridging Configuration Guide (continued)
Chapter Contents/Tasks