Datasheet

Data Sheet
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 10 of 26
Note: Only connections with patch cords with PC or UPC connectors are supported. Patch cords with APC
connectors are not supported. All cables and cable assemblies used must be compliant with the standards specified
in the standards section.
Dimensions
●
Dimensions (H x W x D): 8.5 x 13.55 x 56.5 mm
Environmental Conditions and Power Requirements
Operating temperature range:
●
Commercial temperature range: 0 to 70°C (32 to 158° F)
●
Storage temperature range: -40 to 85°C (-40 to 185° F)
Table 15 presents the optical parameters, and Table 16 presents the maximum power consumption.
Table 15. Optical Parameters
SFP+ Type Average Transmit Power
(dBm)
*
Average Receive Power
(dBm)
Transmit and Receive
Wavelength
Max Min Max Min
SFP-10G-SR 10GBASE-SR 850 nm MMF -1.2
**
-7.3 -1.0 -9.9 840 to 860
SFP-10G-LR 10GBASE-LR 1310 nm SMF +0.5 -8.2 .05 -14.4 1260 to 1355
*
Transmitter and receiver power is in average, unless specified.
**
The launch power shall be the lesser of the class 1 safety limit or the maximum receive power. Class 1 laser requirements are
defined by IEC 60825-1: 2001.
Table 16. SFP+ Modules Maximum Power Consumption
Product Power Consumption (W)
SFP-10G-SR 1
SFP-10G-LR 1
SFP-H10GB-CU1M 1
SFP-H10GB-CU3M 1
SFP-H10GB-CU5M 1
SFP-H10GB-ACU7M 1
SFP-H10GB-ACU10M 1
Regulatory and Standards Compliance
Standards:
●
GR-20-CORE: Generic Requirements for Optical Fiber and Optical Fiber Cable
●
GR-326-CORE: Generic Requirements for Single-Mode Optical Connectors and Jumper Assemblies
●
GR-1435-CORE: Generic Requirements for Multifiber Optical Connectors
●
IEEE 802.3ae (-SR, -LRM, LR)
●
SFP+ MSA SFF-8431 (Optical Modules and Passive Twinax cables)
●
SFP+ MSA SFF-8461 (Active Twinax cables)