User`s guide

EXPLORER

HDTV SETUP WIZRD (CONTINUED)

SETTING UP YOUR HDTV WITH THE SETUP WIZRD

Before you begin to set up your HD terminal using the Setup Wizard,

there are two things you need to do:

• Download the latest information to the set-top. (You only need to do this for the initial setup. After the initial set up,

programming information is downloaded to the set-top automatically on a regular basis.)

• Prepare the set-top to send picture formats that your HDTV supports.

Download the latest programming information to the set-top

Assuming that you have connected the Y, Pb, Pr ports on the back of the set-top to one of the video ports on the HDTV,

complete the following steps to download latest software, programming, and service information to the set-top. (Be sure

you have made a note of which video input port the set-top is connected to on the HDTV. For example: Video input port 6.)

Note: You only need to do this for the initial setup.

1. Plug the set-top and the TV into an AC power source.

2. Do not turn on the set-top or TV yet.

3. Wait until you see one of the following displays on the front of the set-top:

• Current time

• Four dashes (- - - -)

Important : It may take several minutes for the set-top to receive the latest software, programming, and service

information. When the front panel displays the time or four dashes, the update is complete.

4. STOP! Before you turn on the TV or the set-top, you should have read the information in the Picture Formats section,

earlier in this guide.