Installation Guide

10
Attach the MR78-HW/GR62-HW to the Mount Cradle
(This section applies to wall and/or solid ceiling where you have already installed the mount cradle.)
The MR78-HW/GR62-HW attaches to the mount cradle with two tabs on the cradle that insert into the MR78-HW/GR62-HW, and is secured to the cradle using
one screw.
To attach the MR78-HW/GR62-HW to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle. Since the cradle is already
mounted to the wall, guide the MR78-HW/GR62-HW towards the top tab and insert the top tab into the MR78-HW/GR62-HW’s slot.
Then, adjust the MR78-HW/GR62-HW to guide the MR78-HW/GR62-HW’s bottom slot into the cradle’s bottom tab until it clicks into place. Once in place, the
MR78-HW/GR62-HW should be secured to the cradle by using one of the included screws in the cradle’s bottom tab.