Datasheet

642 -531
Leading the way in IT testing and certification tools, www.testking.com
- 105 -
C. Maintenance partition for the blade
D. Service partition
Answer: C
Explanation:
Re-imaging the IDS Module from the Maintenance Partition
You can re-image the IDS module from the maintenance partition. After you re-image the
IDS module, you must initialize the IDS module using the setup command.
Recovering the Software Image
You can recover the software image for the IDS module if it becomes unusable. If you install
a service pack on an IDS module, for example, and it is unusable after it reboots, you must
reimage the IDS module from the maintenance partition.
Reference:
Cisco Courseware 17-17 for the recovery of a Sensor
Appliance
QUESTION NO: 2
Which of the following statements regarding using IDS MC to upgrade a Cisco IDS
Sensor is valid?
A. IDS MC can be used to update signature files only.
B. IDS MC can be used to update service packs only.
C. Update IDS MC prior to updating the Sensor.
D. There are no special requirements for IDS MC.
Answer: C
Explanation: Because ids mc push the upgrade to sensors.
Cisco Courseware 17-4
QUESTION NO: 3
What will you advice the new TestKing trainee technician to use in order to maintain
network connectivity when upgrading IDS-4220 or IDS-4230-FE Sensor appliances from
Cisco IDS v3.x?
A. Swap the console and monitoring interface connections
B. Swap the console and control interface connections
C. Swapping the interface connections is not necessary
D. Swap the control and monitoring interface connections
Answer: D
Cisco Courseware 7-16 Cable swap on the 4230 Sensor