Datasheet

642 -531
Leading the way in IT testing and certification tools, www.testking.com
- 162 -
QUESTION NO: 5
What command could you use on your PIX Firewall to view the current names and
security levels for each interface?
A. Show ifconfig
B. Show nameif
C. Show all
D. Ifconfig /all
Answer: B
Explanation:
Use the show nameif command to determine which interface is being described in a message
containing this variable.
Reference: Cisco PIX Firewall Software Introduction
QUESTION NO: 6
Which of the following commands let you view, change, enable, or disable the use of a
service or protocol through the PIX Firewall?
A. fixing protocol
B. set firewall
C. fixup protocol
D. change –all fix
Answer: C
Explanation:
The fixup protocol commands let you view, change, enable, or disable the use of a service or
protocol through the PIX Firewall. The ports you specify are those that the PIX Firewall
listens at for each respective service.
Reference: Cisco PIX Firewall Command Reference, Version 6.3
Note: In Appendix B of the Cisco Secure Intrusion Detection System 4 Fixup protocol is not
talked about.
QUESTION NO: 7
Debugging a PIX is what you want to do to resolve a problem.
What command would you use to display the current state of tracing?
A. show debug
B. debug all
C. all on debug