Datasheet

642 -531
Leading the way in IT testing and certification tools, www.testking.com
- 27 -
vlans...] [create]
Reference:
Cisco Courseware 5-25
QUESTION NO: 5
Study the exhibit below carefully:
According to the exhibit which command represents a valid configuration step to permit
the IDSM-2 to monitor traffic sent to and from VLAN3, VLAN4, and VLAN5?
A. 6500(config)# monitor session 1 source vlan 3, 4, 5 both
B. 6500(config)# monitor session 1 destination idsm
C. This feature is not supported in this configuration.
D. 6500>(enable) set span source vlan-list 3- 5 destination interface 8/1 both create
E. 6500>(enable) set span 3 – 5 8/1 both
Answer: A
Explanation:
Switch(config)# monitor session {session_number} {source {interface type/num} | {vlan vl
an_ID}} [, | - | rx | tx | both]
Specifies the SPAN session number (1 through 6), the source interfaces (FastEthernet or
GigabitEthernet), or VLANs (1 through 1005), and the traffic direction to be monitored.
Reference:
Cisco Courseware 5-20
QUESTION NO: 6
What function does the mls ip ids command perform when used for traffic capture?
A the mls ip ids command assigns a port to receive capture traffic
B the mls ip ids command selects all IP traffic for IDS monitoring
C the mls ip ids command applies the IDS ACL to an interface