Datasheet

642 -531
Leading the way in IT testing and certification tools, www.testking.com
- 31 -
A. fasthub(config)# monitor session 1 source interface fastEthernet 0/5 tx
B. fasthub(config)# monitor session 1 source interface fastEthernet 0/5 rx
C. fasthub(config-if)# port monitor fastEthernet 0/5
D. fasthub>(enable) set span 0/5 0/24 both
E. No SPAN configuration is required since both devices are in the same VLAN
Answer: E
Explanation:
We must agree with the conclusion that this is nonsense, but E must be the correct answer
since a hub a layer 2 device meaning that it doesn’t do network segmenting. All devices
connected to the hub wil receive the same traffic.
QUESTION NO: 12
Study the exhibit below carefully:
According to the exhibit all switches are connected through Fast Ethernet connections.
Server TestKing3 is in VLAN 8. The Catalyst 4000 is running Catalyst OS. Which of the
following commands represents a valid configuration step to permit IDS3 to monitor
traffic sent to and from Server TestKing3?
A. 4000(config)# monitor session 1 source vlan 8 both
B. 4000(config)# monitor session 1 destination interface fastEthernet 3/24
C. 4000>(enable) set span 3/5 3/24 both create
D. 4000(config)# monitor session 1 source fastEthernet 3/5 destination fastEthernet
3/24 tx rx
E. 4000(config-if)# port monitor interface fastEthernet 3/5
F. This feature is not supported in this configuration
Answer: C
Cisco Courseware 5-18
QUESTION NO: 13
Identify two basic steps in the configuration of VACLs for traffic capture on a Catalyst
6500 switch running IOS. (Choose two.)
A. Configure match clauses using the capture option.