Troubleshooting guide

Software Upgrade Procedures

Note The following procedure for software installation of Release 2.0.9 causes ﬂash memory to be

reloaded. The ﬂash reload time depends on your system conﬁguration. Also, you must explicitly

reload switch card ﬂash memory according to the installation procedure.

Requirements for Upgrade

For Release 2.0.9 to be installed, the network processor must have 32 Mb of memory.

For Release 2.0.9 to be installed successfully, you must currently be running at least Release 2.0.3

software.

You must have a modem in each remote node to which the software upgrade is to be sent. Refer to

the section entitled “Modem Recommendations” in the LightStream 2020 Site Planning and Cabling

Guide.

Caution The LightStream 2020 NP is a special-purpose communications processor. It should not

be used as a general-purpose UNIX host. If any ﬁles have been copied to or placed on the disk

(especially in the root partition), they should be removed before the upgrade to release 2.0.9. If the

names of any Cisco-provided ﬁles have been changed, the original ﬁle names should be restored.

Distribution Media

Below is a list of the LightStream 2020 Release 2.0.9 node software distribution diskettes.

LightStream 2020 Release 2.0.9

Distribution Diskettes

Version Listed on

Diskette Label

Boot Disk 2.0.9

System Disk 1 2.0.9

System Disk 2 2.0.9

System Disk 3 2.0.9

Application Disk 1 2.0.9

Application Disk 2 2.0.9

Application Disk 3 2.0.9

Application Disk 4 2.0.9

Application Disk 5 2.0.9

Application Disk 6 2.0.9

Diagnostic Disk 1 2.0.9

Diagnostic Disk 2 2.0.9

Firmware Disk 1 2.0.9

Firmware Disk 2 2.0.9