Datasheet

25
OL-17436-01
Checking the Installation
Table 7 Single PRP-3 Alphanumeric Display LED—Chassis Is Powered ON or PRP-3 Board Inserted
1. The version of microcode running on your PRP might be different.
PRP-3 ALphanumeric LEDs
The following section discusses the alphanumeric LED messages and the console output displayed in
sequence for a single PRP-3 and for dual PRP-3s. The alphanumeric LED messages help in identifying
the state of the route processor and accordingly troubleshooting the problems faced.
Single PRP-3 Scenario
Table 7 displays the alphanumeric LED messages and the console output when the chassis is powered
on or when the PRP-3 board is inserted into the slot.
LED Display Description or Console Message
02A8/HW
OK/RIO
Immediately when the board is powered on.
OK/CPU
SENT/RPT
Displays "1.330GHz dual-core MPC8641D Rev 2.1, 532MHz MPXclk".
INIT/MEM Displays "Discovering memory in slot DIMM1 ......................... Found 2GB
DIMM
Discovering memory in slot DIMM2 ......................... Found 2GB DIMM"
TEST/MEM Displays "Testing low memory ....................................... OK
Loading main ROMMON image ................................ OK
Verifying loaded image ................................... OK
Load succeeded; launching target ......................... OK"
LNCH/RMON Displays “Cisco ROMMON System Bootstrap, Version 0.16.0 (bld1)
DEVELOPMENT SOFTWARE
Compiled on 08/27/08 at 15:04:49 PDT [BLD-rommon]
Copyright (c) 1994-2008 by Cisco Systems, Inc.
MPC8641D platform with 4 GB of main memory"
RDY/RP DISPLAYS "Loading disk0:c12k-os-mbi-3.8.0.15I/mbiprp-rp.vm (14809672
bytes)... !!!"