Datasheet

OL-17436-01

Upgrading to the PRP

Image Version = Cisco Internetwork Operating System

Software

IOS (tm) GS Software (GSR-P-M), Version 12.0(26)S, EARLY DEPLOYMENT

RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Compiled Mon 25-Aug-03 10:44 by nmasa

BOOT =

CONFIG_FILE =

BOOTLDR =

Configuration register = 0x2102

Peer Processor Information :

----------------------------

Standby Location = slot 4

Current Software state = STANDBY HOT

Uptime in current state = 2 hours, 13 minutes

Image Version = Cisco Internetwork Operating System

Software

IOS (tm) GS Software (GSR-P-M), Version 12.0(26)S, EARLY DEPLOYMENT

RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Compiled Mon 25-Aug-03 10:44 by nmasa

BOOT =

CONFIG_FILE =

BOOTLDR =

Configuration register = 0x2102

Step 2 Remove the Flash disk from the PRP card and install it into slot 1 of the active RP. The following

message will be displayed; do not format the disk.

22:21:31: %PCMCIAFS-5-DIBERR: PCMCIA disk 1 is formatted from a different router or PC. A

format in this router is required before an image can be booted from this device

Note If your router is running an image prior to Cisco IOS Release 12.0(25)S2, you are advised to

insert the Flash disk into slot 1 of the standby RP, and not the active RP.

Step 3 Verify the disk contents using the dir disk1: command (or the dir stby-disk1: command if the Flash

disk is in the standby RP).

Router# dir disk1:

Directory of disk1:/

1 -rw- 17329392 Dec 3 2003 11:44:46 +00:00 c12kprp-p-mz.120-27.S

63832064 bytes total (46465024 bytes free)

Step 4 If the Cisco IOS version is not the same as the one running on the GRPs, delete the image from the disk

using the delete disk1: filename command (or the delete stby-disk1:filename command if the Flash disk

is in the standby RP). If the image is correct, continue with Step 7.

Note Before you delete the image, verify that you have a copy of this image on another disk or at

another location.