Datasheet

Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Small Form Factor Disk Drive Model)

CONFIGURING the SERVER

— If any of the Fusion ioDrive2 cards are installed, they must be plugged into slot 1.

Note that only the Cisco UCS 3.0 TB MLC Fusion ioDrive2 and Cisco UCS 5200 GB

Fusion ioMemory3 cards are full-height; all other Fusion io cards are half-height and

therefore may need an adapter to hold them securely in the full-height slot.

■ For 2-CPU systems:

— Both PCIe slots (slots 1 and 2) and the mezzanine card slot are supported

— Only a single VIC card (the half-height Cisco VIC 1225 or 1285 PCIe card) is supported

and it must be installed in slot 1 (the full height slot).

— Only a single Cisco UCS 3.0 TB MLC Fusion ioDrive2 or Cisco UCS 5200 GB Fusion

ioMemory3 card is supported and it must be installed in slot 1 (the full height slot).

— Up to two of the other Fusion io cards are supported and can be installed in either

slot 1 or 2, although an adapter may be needed when installing one of these

half-height cards in slot 1 (the full-height slot).

■ Other considerations for the Cisco VIC 1225 or 1285:

— Supports 10G SFP+ optical and copper twinax connections

— The server supports installation of one Cisco VIC card and it is supported only in PCIe

slot 1.

— Requires that the server has CIMC firmware version 1.4(6) or later installed. There is

a heartbeat LED on the top of the card that indicates when firmware is active.

— To use this card for UCS integration (Cisco UCS Manager mode) with Cisco UCS

Manager 2.1(0) or later, the minimum card-firmware and uboot image level is

2.1(0.306).

■ To help ensure that your operating system is compatible with the card you have selected,

check the Hardware Compatibility List at this URL:

http://www.cisco.com/en/US/products/ps10477/prod_technical_reference_list.html