Datasheet

Data Sheet
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 5 of 6
System Requirements
●
A maximum of one NM-1A-T3/E3 Network Module is supported on the Cisco 2811,2821,2851 and 3845.
Two are supported on the Cisco 3845. Line rate performance is not guaranteed for maximum NM-1A-T3/E3
Network Module support on the platforms.
●
Operates in conjunction with all currently available Cisco 3800 network modules and WAN interface cards
(WICs) and with all currently available Cisco 3900 Network Modules, Service Modules, Internal Services
Modules, EHWICs, HWICs, WICs and VICs.
●
No slot placement restrictions
●
Support for the DS3/E3 ATM network module in the 3925, and 3945 will be via the network module adapter
card (SM-NM-ADPTR).
Network Management
Supported MIBs include:
●
Synchronous Optical Network (SONET) MIB
●
MIB II
●
AToM MIB (FRC 1695)
●
ILMI MIB
●
CISCO-BUS MIB
●
CISCO-LECS-MIB
●
CISCO-LES-MIB
●
LAN Emulation (LANE) MIB
●
Cisco-AAL5-MIB
●
DS3/E3 CISCO-ATM-IF-PHYS-MIB
Product Compliance Standards
The DS-3 and E3 ATM network modules are to receive all the agency approvals necessary for unlimited international
availability. The following regulatory approvals are supported:
Environmental
Table 7. DS3/E3 ATM Physical Specifications
Product Specifications Descriptions
Dimensions (H x W x D) 1.55 x 7.10 x 7.2 in
Weight 2 lbs. Maximum
Environmental Conditions
●
Operating temp. 41-131°F (+5 -+55°C)
●
Non-operating temp. -13-158°F (-25-70°C)
Relative Humidity 0 to 90%, noncondensing
EMI Class B EMI
Cabling 75 Ohm BNC type connector
LEDs Enabled, RX cells, RX carrier, RX Alarm