Datasheet

Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Connecting Cisco CEoIP Network Modules to the
Network
Revised: May 1, 2008, OL-12829-01
This guide describes how to connect Cisco Circuit Emulation Over IP (CEoIP) network modules to your
network. It contains the following sections:
Cisco CEoIP Network Modules, page 1
4-Port Serial Interface Network Modules (NM-CEM-4SER), page 2
Connecting 4-Port Serial Interface Network Modules to the Network, page 3
4-Port T1/E1 RJ-48 Interface Network Modules (NM-CEM-4TE1), page 8
Connecting 4-Port T1/E1 RJ-48 Interface Network Modules (NM-CEM-4TE1) to the Network,
page 9
Related Documents, page 10
Obtaining Documentation, Obtaining Support, and Security Guidelines, page 10
Cisco CEoIP Network Modules
Cisco CEoIP network modules provide a virtual circuit through an IP network (similar to a leased line).
Transport of data, regardless of the content or structure of the data stream, is entirely transparent to the
destination; bits arriving at one end are delivered unchanged to the destination address.
This chapter provides information on the following two Cisco CEoIP network modules:
4-port serial interface network module (NM-CEM-4SER), shown in Figure 1
4-port T1/E1 RJ-48 interface network module (NM-CEM-4TE1), shown in Figure 2

Summary of content (12 pages)