Datasheet

Connecting Cisco Unity Express Network Modules to the Network

Online Insertion and Removal with a Cisco Unity Express Network Module

Connecting Cisco Unity Express Network Modules to the Network

Step 4 On the router, clear the Cisco Unity Express network module console access session by using the

following command:

Router# service-module service-engine slot/port session clear

Step 5 Perform a graceful halt of the Cisco Unity Express network module disk drive by using the following

command:

Router# service-module service-engine slot/port shutdown

Step 6 Loosen the two captive screws holding the Cisco Unity Express network module in the chassis slot.

Step 7 Slide the Cisco Unity Express network module out of the slot.

Step 8 Align the replacement Cisco Unity Express network module with the guides in the chassis slot, and slide

it gently into the slot.

Note If the router is not fully configured with network modules, make sure that blank panels fill the

unoccupied chassis slots to provide proper airflow.

Step 9 Push the module into place until you feel its edge connector mate securely with the connector on the

backplane.

Step 10 Tighten the two captive screws on the module faceplate.

Step 11 Check that the network module LEDs come on and that the power and enable LEDs on the front panel

have also come on. This inspection ensures that connections are secure and that the new unit is operational.

Step 12 Initiate a Cisco Unity Express network module console access session with the following command:

Router# service-module service-engine slot/port session

Trying 10.10.10.1, 2129 ... Open

SE-netmodule con now available

Press RETURN to get started!

SE-netmodule> enable

SE-netmodule#

Step 13 Restore the Cisco Unity Express running configuration by using the following command from the

SE-netmodule prompt:

SE-netmodule# copy ftp: running-config

Address or name or remote host? username/password/remote host

Source filename? filename

Step 14 Exit the Cisco Unity Express network module console access session by pressing Ctrl-Shift-6, followed

by x .

Step 15 On the router, clear the console access session using the following command:

Router# service-module service-engine slot/port session clear