Specifications
Table Of Contents
- Contents
- Prerequisites for Installing the Cisco WAE Network Modules
- Restrictions for Cisco WAE Network Modules
- Cisco WAE Network Module Hardware Description
- Setting Up Cisco WAE Network Modules and Opening a Session
- Starting the Cisco WAE Network Module and Displaying Status
- Command Reference
- Glossary
- Related Documentation
- Obtaining Documentation, Obtaining Support, and Security Guidelines
16
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
interface integrated-service-engine
interface integrated-service-engine
To enter the interface configuration mode for an integrated-service-engine (ISE) network module, use
the interface integrated-service-engine command in global configuration mode.
interface integrated-service-engine slot/unit
Syntax Description
Defaults None
Command Modes Global configuration
Command History
Usage Guidelines This command is used only for ISE network modules. If your router does not have this hardware, then
you will not be able to enter this command.
A no form of this command (no interface integrated-service-engine) is not available. Use the exit
command to exit the interface configuration mode.
Examples The following example shows how to enter configuration mode for ISE network modules located in slot
1, unit 0:
Router (config)# interface integrated-service-engine 1/0
Router (config-if)# exit
slot Slot number of the interface.
unit Number of the daughter card on the network module. For ISE network
modules, always use 0.
Release Modification
12.4(9)T This command was introduced for ISE network modules.