Installation Guide

Port LEDs7PON ports3
--1 G combo ports4
Rear Panel
This section describes the rear-panel components of CGP-OLT-16T:
Figure 4: Rear Panel of CGP-OLT-16T
Grounding connector2AC or DC power connector1
Ports
PON Ports
The PON ports use multi-source agreement (MSA) type UPC or SC-PC fiber connector. The PON ports
support a bandwidth of 2.466 Gbps downstream and 1.244 Gbps upstream.
Console Port
The console port connects the Cisco Catalyst PON Series OLT to a PC running Microsoft Windows or to a
terminal server and uses the RJ-45 crossover cable. The RJ-45 console port connection uses the supplied
RJ-45-to-DB-9 female cable.
Auxiliary Port
The auxiliary port connects the Cisco Catalyst PON Series OLT to a host such as a Windows workstation or
a terminal server through the auxiliary port. The auxiliary out-of-band management port is a virtual routing
and forwarding (VRF) interface and uses an RJ-45 crossover cable.
1 G Combo Ports
A combo port is a combination of an SFP interface and an RJ-45 port. When the SFP interface is active, the
adjacent RJ-45 port is disabled. The 1 G ports use LC connectors for fiber-optic connections and RJ-45
connectors for copper connections.
10 G SFP+ Ports
The 10 G ports use LC connector cables for fiber-optic connections and RJ-45 connector cables for copper
connections. The SFP slots support only SFP+ modules. These SFP+ modules are field replaceable, and
provide uplink interfaces when installed in an SFP+ module slot.
Cisco Catalyst PON Series Switches Hardware Installation Guide
4
Introduction to the Passive Optical Network
Rear Panel
REVIEW DRAFT - CISCO CONFIDENTIAL