Installation Guide
Table Of Contents
- Cisco Catalyst PON Series Switches Hardware Installation Guide
- Contents
- Preface
- Introduction to the Passive Optical Network
- Removing and Replacing Field-Replaceable Units (FRUs)
- Troubleshooting
- Technical Specifications
- Connector and Cable Specifications
DC Power Supply
The following table lists the power supply ratings.
Output Power (Watts)Input Voltage (VAC)
100-36 to -72VDC (with extended range upto -75VDC)
Voltage differential between inputs is unlimited.
LEDs
You can use LEDs to monitor the activity and performance of Cisco Catalyst PON Series OLT.
Table 2: System LEDs
IndicationColorLED
Normal power from power supplyGreen (solid)PWR1 and PWR2
No power from power supplyOFF
OLT is running normally
Green (blinking)RUN
OLT is not running
or
OLT is running abnormally
OFF
or
Green (solid)
Auxiliary port is not connected
OFFAUX
Auxiliary port is connected, but not
transmitting data
Green (solid)
Auxiliary port is connected and is
transmitting data
Green (blinking)
Power supply is normal
Green (solid)OUT
No power supplyOFF
Cisco Catalyst PON Series Switches Hardware Installation Guide
6
Introduction to the Passive Optical Network
LEDs
REVIEW DRAFT - CISCO CONFIDENTIAL