Installation Guide

Ports
1 G 10/100/1000 PoE Ports
The Ethernet ports use RJ-45 connector cables with Ethernet pinouts. The 10BASE-T, 100BASE-TX, and
1000BASE-T traffic requires Category 5 or Category 5e twisted pair (UTP) cable. The 10BASE-T traffic can
use Category 3 or Category 4 UTP cable.
The ports also provide PoE support for devices that are compliant with IEEE 802.3af and IEEE 802.3at.
FXS Ports
The FXS ports use RJ-11 telephone cables.
PON Port
The PON ports use multi-source agreement (MSA) type UPC or SC-PC fiber connector cables. The PON
ports range is from 8 to -29 dBm.
USB Port
A USB type A console port is provided for log and configuration file management.
CATV Port
The CATV port uses a coaxial cable.
LEDs
You can use the LEDs to monitor the activity and performance of Cisco Catalyst PON Series ONT.
Table 5: LEDs on CGP-ONT-1P, CGP-ONT-4P, CGP-ONT-4PV, and CGP-ONT-4PVC
IndicationColorLED
Normal power from power supply.Green (solid)PWR
No power from power supply.OFF
ONT is active and registered
successfully.
Green (solid)PON
ONT is either inactive or being
registered.
Green (flashing)
Loss in optical signal power.Red (flashing)
PON module is not ready.OFF
1 G (1–4)
Power device is connected.Amber (solid)
Right LED
Power device is not connected.OFF
Cisco Catalyst PON Series Switches Hardware Installation Guide
13
Introduction to the Passive Optical Network
Ports
REVIEW DRAFT - CISCO CONFIDENTIAL