Specifications

PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration

OL-3743-02

Configuring the HP ESCON PA

Expanding disk0:xcpa27-1_seg_push (15488 bytes):!!!!!!!!!!!

Expanding disk0:xcpa27-1_seg_tcpip (161140 bytes):!!!!!!!!!!!

Expanding disk0:xcpa27-1_seg_tn3270 (620400 bytes):!!!!!!!!!!!

[OK - 2739200/5478400 bytes]

2739200 bytes copied in 68.500 secs (40282 bytes/sec)

To update your running configuration:

Step 1 Enter the following commands, beginning in global configuration mode:

Router# configuration term

Router(config)# microcode ecpa

diskX

xcpaXX-YY

Router(config)# microcode reload

Router(config)# end

where:

–

diskX is disk0 or disk1 on the SanDisk device

–

xcpaXX-YY is the xCPA image you want to use, such as xcpa27-1

Step 2 Save the running configuration to NVRAM.

Running HP ESCON PA Diagnostic Tests

The HP ESCON PA diagnostic test routines are as follows:

• Processor test 1

• Processor test 2

• I/O device tests

• Serial link controller (SLC) device tests

• Internal electrical wrap

• External optical wrap for the ESCON Channel Port Adapter

Note All diagnostic tests are run every time the adapter is started. They cannot be run independently. The

external optical wrap test require special wrap plugs for the HP ESCON PA. Contact a service

representative to obtain the appropriate wrap plugs