Datasheet

29
Installing the Power Supply
78-4519-04
Removing and Installing the Cisco AS5350 Power Supply
Installing the Power Supply
To install the power supply, follow this procedure:
Step 1 Place the power supply as shown in Figure 31, then slide it toward the rear panel. You will feel the
chassis hooks engage with the slots on the bottom of the power supply. The same procedure applies to
both the AC and DC power supplies.
Figure 31 Inserting the Power Supply in the Chassis
Step 2
Connect the two power connectors to the system board and backplane. (See Figure 28.) Connect the
system board connector first, followed by the backplane connector. (See Figure 32.)
Note The system board connector is located on the system board, below and left of the backplane
connector.
Power
supply
35695
3
Chassis bottom
Front panel