Datasheet

Replacing the Chassis Cover

78-4519-04

Removing and Installing the Cisco AS5350 Power Supply

Step 4 Reinstall the power supply mounting screw.

Step 5 Replace the chassis cover using the procedures in the “Replacing the Chassis Cover” section on page 31.

Replacing the Chassis Cover

To replace the chassis cover, follow this procedure:

Step 1 Place the chassis bottom so that the front panel is facing you.

Step 2 Hold the chassis cover over the chassis bottom, and align each of the cover tabs with the chassis tabs at

the top rear of the chassis, as shown in Figure 34.

Figure 34 Replacing the Chassis Cover

Step 3

Lower the front of the top cover to close the chassis, and ensure the following:

• The chassis cover tabs fit under the edge of the chassis rear panel so that they are not exposed.

• The chassis tabs fit under the chassis cover so that they are not exposed.

• The chassis cover side tabs on both sides fit inside the chassis side panels so that they are not

exposed.

When the chassis cover is properly assembled, no tabs are visible.

Step 4 Secure the chassis cover with five screws.

Step 5 If you installed a different type of power supply (AC or DC) than was originally installed in the

universal gateway, place one of the power ratings labels that came in the plastic bag with the

documentation directly over the power ratings information on the rear panel. For example, if the

original chassis came with an AC power supply and you replaced it with a DC power supply, place the

DC power ratings label over the ratings stamped on the rear panel of the chassis. This ensures that the

correct power ratings information appears on the rear panel. (See Figure 35 and Figure 36.)

35662

Chassis bottom

Front panel

Chassis cover