User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Introduction
Getting to Know the Cisco RV110W
Cisco RV110W Administration Guide 10
1
Virtual Networks
The Cisco RV110W also supports multiple Service Set Identifiers (SSIDs) for the
use of virtual networks (up to four separate virtual networks), with 802.1Q-based
VLAN support for traffic separation.
Configuration and Administration
With the Cisco RV110W embedded web server, you can configure the
Cisco RV110W settings using the browser-based Device Manager. The
Cisco RV110W supports Internet Explorer, Firefox, and Safari web browsers.
The Cisco RV110W also provides a Setup Wizard that allows you to easily and
quickly configure the Cisco RV110W basic settings.
Getting to Know the Cisco RV110W
Front Panel
Power The Power light is green to indicate the unit is powered
on. The light flashes green when the power is coming
on.
WPS The Wi-Fi Protected Setup (WPS) button is used to
configure wireless access for devices in your network
that are WPS-enabled. See Configuring WPS, page 77
for more information.