User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring VPN
Configuring Advanced VPN Parameters
Cisco RV110W Administration Guide 103
5
Managing VPN Policies
To manage VPN policies:
STEP 1 Choose VPN > IPsec > Advanced VPN Setup.
STEP 2 In the VPN Policy Table, checking the box in the VPN connection row allows you to
perform the following tasks:
• Edit—Edit properties of the VPN policy. See Adding or Editing VPN
Policies.
• Enable—Enable the policy.
• Disable—Disable the policy.
• Delete—Delete the policy.
• Add Row—Add a VPN policy. See Adding or Editing VPN Policies. (Note: If
you have a VPN connection already configured, you cannot add another
without deleting the existing VPN connection.)
STEP 3 Click Save.
Adding or Editing IKE Policies
When adding or editing IKE policies, configure the following settings:
• Policy Name—Enter a unique name for the policy for identification and
management purposes.
• Exchange Mode—Choose one of the following options:
- Main—This mode negotiates the tunnel with higher security, but is
slower.
- Aggressive—This mode establishes a faster connection, but with
lowered security.