User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring VPN
Configuring VPN Passthrough
Cisco RV110W Administration Guide 110
5
STEP 3 Click Save.
IPsec Check Enable to allow IP security tunnels to pass
through the Cisco RV110W.
PPTP Check Enable to allow PPTP tunnels to pass
through the Cisco RV110W.
L2TP Check Enable to allow Layer 2 Tunneling Protocol
(L2TP) tunnels to pass through the Cisco RV110W.