User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring Quality of Service (QoS)
Configuring Bandwidth Management
Cisco RV110W Administration Guide 112
6
STEP 3 In the Bandwidth Table, enter the following information for the WAN interface:
STEP 4 Click Save.
Configuring Bandwidth Priority
In the Bandwidth Priority Table, you can assign priorities to services to manage
bandwidth usage.
To configure bandwidth priority:
STEP 1 Choose QoS > Bandwidth Management.
STEP 2 In the Bandwidth Management field, check Enable. The maximum bandwidth
provided by your ISP appears in the Bandwidth section.
STEP 3 In the Bandwidth Priority Table, click Add Row.
STEP 4 Enter this information:
STEP 5 Click Save.
To edit the settings of an entry in the table, check the relevant box and click Edit.
When you are done making changes, click Save.
Upstream The bandwidth (kb/s) used for sending data to the
Internet.
Downstream The bandwidth (kb/s) used for receiving data from
the Internet.
Enable Check to enable bandwidth management for this
service.
Service Choose the service to prioritize.
Direction Choose the direction of the traffic you want to
prioritize (downstream or upstream).
Priority Choose the priority of the service (low, normal,
medium, or high).