User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Administering Your Cisco RV110W
Upgrading Firmware or Change the Language
Cisco RV110W Administration Guide 132
7
To copy a configuration (for example, to copy a startup configuration to the backup
configuration):
STEP 1 Choose Administration > Backup/Restore Settings.
STEP 2 In the Copy field, choose the source and destination configurations from the drop-
down menus.
STEP 3 Click Start to Copy.
Generating an Encryption Key
The router allows you to generate an encryption key to protect the backup files.
To generate an encryption key:
STEP 1 Choose Administration > Backup/Restore Settings.
STEP 2 Click Show Advanced Settings.
STEP 3 In the box, enter the seed phrase used to generate the key.
STEP 4 Click Save.
Upgrading Firmware or Change the Language
You can upgrade to a newer version of the firmware or change the language of the
router by using the Administration > Firmware/Language Upgrade page.
!
CAUTION During a firmware upgrade, do not try to go online, turn off the device, shut down
the PC, or interrupt the process in any way until the operation is complete. This
process takes about a minute, including the reboot process. Interrupting the
upgrade process at specific points when the flash memory is being written to may
corrupt it and render the router unusable.