User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
2
Cisco RV110W Administration Guide 22
Configuring Networking
This chapter describes how to configure the Cisco RV110W network settings.
• Configuring the WAN Settings
• Configuring the LAN Settings
• Cloning the MAC Address
• Configuring Routing
• Port Management
• Configuring Dynamic DNS
• Configuring the IP Mode
• Configuring IPv6
Configuring the WAN Settings
Configuring WAN properties for an IPv4 network differs depending on which type
of Internet connection you have.
Configuring Automatic Configuration (DHCP)
If your Internet Service Provider (ISP) uses the Dynamic Host Control Protocol
(DHCP) to assign you an IP address, you receive a dynamic IP address that is
newly generated each time you log in.
To configure DHCP WAN settings:
STEP 1 Choose Networking > WAN.
STEP 2 From the Internet Connection Type drop-down menu, choose Automatic
Configuration - DHCP.