User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring Networking
Configuring the LAN Settings
Cisco RV110W Administration Guide 37
2
STEP 3 In the Setting Table, configure the following settings:
STEP 4 Click Save.
Port Management
You can configure the speed and flow control settings of the Cisco RV110W LAN
ports.
To configure port speeds and flow control:
STEP 1 Choose Networking > Port Management.
Forward Delay The forward delay is the interval after which an
interface changes from the blocking to forwarding
state. Enter a number from 4 to 30. The default is
15.
Force Version Select the default protocol version to use. Select
Normal (use RSTP) or Compatible (compatible
with old STP). The default is Normal.
Protocol Enable Check to enable RSTP on the associated port.
RSTP is disabled by default.
Edge Check to specify that the associated port is an
edge port (end station). Uncheck to specify that the
associated port is a link (bridge) to another STP
device. Edge port is enabled by default.
Path Cost Enter the RSTP path cost for the designated ports.
Use 0 for the default value (the Cisco RV110W
automatically determines the path value). You can
also enter a number from 2 to 200000000.