User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring Networking
Configuring IPv6
Cisco RV110W Administration Guide 55
2
STEP 5 Enter the following information:
• IPv6 Prefix
• IPv6 Prefix Length
• Border Relay
• IPv4 Mask Length.
STEP 6 Click Save.
4 to 6 Tunneling
IPv4 to IPv6 tunneling (4-to-6 tunneling) allows IPv4 packets to be transmitted over
an IPv6 network. To configure 4-to-6 tunneling:
STEP 1 Select Networking > IPv6 > Tunneling.
STEP 2 In the 4 to 6 Tunneling field, check Enable.
STEP 3 Enter the local WAN IPv6 address on the Cisco RV110W.
STEP 4 Enter the Remote IPv6 address, or the IP address of the remote endpoint.
STEP 5 Click Save.
Viewing IPv6 Tunnel Status
To view IPv6 tunnel status:
STEP 1 Choose Networking > IPv6 > IPv6 Tunnels Status.
STEP 2 Click Refresh to display the most up-to-date information.
This page displays information about the automatic tunnel set up through the
dedicated WAN interface. The table shows the name of tunnel and the IPv6
address that is created on the device.