User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring the Wireless Network
Configuring Basic Wireless Settings
Cisco RV110W Administration Guide 63
3
Configuring Basic Wireless Settings
You can use the Basic Settings page (Wireless > Basic Settings) to configure
basic wireless settings.
To configure basic wireless settings:
STEP 1 Choose Wireless > Basic Settings.
STEP 2 In the Radio field, check Enable to turn on the wireless radio. By default there is
only one wireless network enabled, ciscosb1.
STEP 3 In the Wireless Network Mode field, choose one of these options from the
drop-down menu:
Wireless
Isolation
with SSID
Disabled Disabled Disabled Disabled
WMM Enabled Enabled Enabled Enabled
WPS
Hardware
Button
Enabled Disabled Disabled Disabled
1. When using the Setup Wizard, select Best Security or Better Security to protect the
Cisco RV110W from unauthorized access.
SSID Name ciscosb1 ciscosb2 ciscosb3 ciscosb4
B/G/N-Mixed Choose this option if you have Wireless-N,
Wireless-B, and Wireless-G devices in your
network. This is the default setting (recommended).
B Only Choose this option if you have only Wireless-B
devices in your network.
G Only Choose this option if you have only Wireless-G
devices in your network.
N Only Choose this option if you have only Wireless-N
devices in your network.