User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring the Wireless Network
Configuring Advanced Wireless Settings
Cisco RV110W Administration Guide 73
3
Configuring Advanced Wireless Settings
Advanced wireless settings should be adjusted only by an expert administrator;
incorrect settings can reduce wireless performance.
To configure advanced wireless settings:
STEP 1 Choose Wireless > Advanced Settings. The Advanced Settings page appears.
STEP 2 Configure these settings:
Frame Burst Enable this option to provide your wireless networks
with greater performance, depending on the
manufacturer of your wireless products. If you are not
sure how to use this option, keep the default (enabled).
WMM No
Acknowledgement
Click to enable this feature.
Enabling WMM No Acknowledgement can result in more
efficient throughput, but higher error rates in a noisy
Radio Frequency (RF) environment. Default setting is
disabled
Basic Rate The Basic Rate setting is not the rate of transmission but
a series of rates at which the Services Ready Platform
can transmit. The Cisco RV110W advertises its basic
rate to the other wireless devices in your network, so
they know which rates will be used. The Services Ready
Platform will also advertise that it will automatically
select the best rate for transmission.
The default setting is Default, when the Cisco RV110W
can transmit at all standard wireless rates (1 Mbps, 2
Mbps, 5.5 Mbps, 11 Mbps, 18 Mbps, 24 Mbps, 36 Mbps,
48 Mbps, and 54 Mbps). In addition to B and G speeds,
the Cisco RV110W supports N speeds. Other options
are 1-2 Mbps, for use with older wireless technology,
and All, when the Cisco RV110W can transmit at all
wireless rates.
The Basic Rate is not the actual rate of data transmission.
If you want to specify the Cisco RV110W rate of data
transmission, configure the Transmission Rate setting.