User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring the Wireless Network
Configuring WPS
Cisco RV110W Administration Guide 78
3
WPS Method 2
Use this method if the client device has a WPS PIN number.
STEP 1 On the WPS page, enter the PIN number in the field.
STEP 2 Click Register.
STEP 3 After configuration is completed, click OK.
Refer to your client device or its documentation for further instructions on setting
up your client device.
WPS Method 3
If the client device requires a PIN number from the router, use the number listed in
item 3 on the WPS page.