User guide

Using the Cisco SPA 500S Attendant Console
Using the Cisco SPA 500S
Cisco Small Business IP Phone SPA 525G/SPA 525G2 User Guide (SIP) 111
6
NOTE The options available on the Cisco SPA 500S depend on the phone system
configuration. Your phone system might not provide all of the features mentioned in
this document.
Configuration of the Cisco SPA 500S and assignment of the line buttons is
performed by the phone administrator and is not described in this document. To
configure the Cisco SPA 500S:
• If the Cisco SPA 500S and attached Cisco SPA 525G/525G2 are part of a
Cisco SPA 9000 Voice System, we recommend that you use the Cisco SPA
9000 Setup Wizard. For instructions on using the Setup Wizard, see the
System Configuration Using the SPA 9000 Setup Wizard document on
Cisco.com. See Appendix A, “Where to Go From Here” for the location of
this document.
• If you want to manually configure the Cisco SPA 500S using the web user
interface for the Cisco SPA 525G/525G2 to which the Cisco SPA 500S is
attached, see the
Cisco SPA 500 Series and Wireless IP Phone
Administration Guide
on Cisco.com. See Appendix A, “Where to Go From
Here” for the location of this document.
• If the Cisco SPA 500S and attached Cisco SPA 525G/525G2 are used with
a Broadsoft or Asterisk server, see the
Cisco SPA 500 Series and Wireless
IP Phone Administration Guide
on Cisco.com. See Appendix A, “Where to
Go From Here” for the location of this document.
Using the Cisco SPA 500S
The functions of Cisco SPA 500S buttons may differ depending on configuration.
However, in general, you can:
• Monitor an extension by viewing its color. The LED color of a line button
gives you information about the line being monitored:
- Green: The line is idle.
- Red (steady): The line is in use.
- Red (blinking): The line is ringing.
- Orange (steady): The line is not registered; there is a problem with phone
connectivity.