User guide

4
CHAPTER 2 INSTALLING CISCO SPA502 OR CISCO SPA504
Connecting your phone
Turn your phone over to expose the ports on the back of the
unit
Insert one end of the ‘curly’ phone cable into the port marked
‘HAC’ on the back of the phone
Insert the other end of the ‘curly’ phone cable into the port at
the bottom of the handset
Connect the phone stand by lining up the tabs on the stand
with the slots on the phone body. Slide the bottom tabs into
the lower slots on the phone body and lightly press down on
the stand
Connect your phone to the network. Insert one end of the
Ethernet cable into the ‘SW’ LAN port on the back of the
phone. Insert the other end of the network cable into any
available Ethernet LAN (10/100) port on the router.
To provide network access to a PC and reduce the number
of Ethernet cables connected to the router, connect one end
of an additional Ethernet cable (not provided) to the port
marked “PC” on the back of the phone. Connect the other
end of the Ethernet cable to the network port on your
PC/computer.
Connect one end of the power cord into the power socket at
the back of the phone. Make sure the power source is
switched OFF, and then connect the other end of the power
cord into the power socket. Switch the power source ON.
After a few moments a small phone icon will be displayed on
the top right hand corner of the phone’s LCD screen. (figure
1)
Now you are ready to set-up your user profile.
Setting up your profile
The user profile must be set-up before you can use the
phone.
‘login’ will be displayed at the bottom left hand corner of the
LCD screen
Press the soft key beneath ‘login’ to select ‘login’ (figure 1)
Enter the Device ID and Password (obtain this information
from the Configuration Summary email received from Telstra)
using the number pad. Press the ok soft key (figure 2)
The phone will restart by itself and a ‘Ready’ message will
appear. The phone is now ready for use. (figure 3)
Figure 1: Initial screen
Figure 2: UserID and Password entry
Figure 3: Ready to use
Back of Phone
Handset
PC port
SW
LAN
DC5V Power
plug