Specifications

7-20
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 7 Configuring Voice Mail
Configuring System-Wide Voice-Mail Parameters
Examples
For examples of the output from the following commands, see the “Examples” section on page 18.
• show voicemail detail mailbox
• show voicemail conversation caller caller-flow restriction table
• show running-config
Configuring System-Wide Voice-Mail Parameters
The following system-wide parameters are configurable for all voice mailboxes.
• Capacity—Total amount of storage time in hours allowed for all mailboxes in the system. The
factory default is the maximum allowed storage for your system.
• Mandatory message expiry—Enabling this feature forces all subscribers to delete voice-mail
messages when the messages expire. Subscribers will not have the option to keep the messages.
Mandatory message expiry is disabled by default.
After mandatory message expiry is enabled on the system, the TUI does not allow expired messages
to be saved or resaved.
The message expiration is calculated using the message delivery time, not the last time the message
was saved.
Forwarding messages to oneself is not allowed.
Step 5
voicemail conversation caller caller-flow
restriction-table restriction-tablename
se-10-0-0-0(config)# voicemail conversation caller
caller-flow restriction-table call-flow restriction
(Optional) Configures the restriction table that limits
the scope of a call transfer through a call flow.
Step 6
end
Example:
se-10-0-0-0(config)# end
Exits to privileged EXEC mode.
Step 7
show voicemail detail mailbox name
Example:
se-10-0-0-0# show voicemail detail mailbox user-8
(Optional) Displays information about a mailbox.
Step 8
show voicemail conversation caller caller-flow
restriction-table
Example:
se-10-0-0-0# show voicemail conversation caller
caller-flow restriction-table
(Optional) Displays information about the restriction
table that limits the scope of a call transfer through a
call flow.
Step 9
show running-config
Example:
se-10-0-0-0# show running config
(Optional) Displays the running configuration file.
Command or Action Purpose