Specifications

13-7
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 13 Networking Cisco Unity Express
Configuring Network Locations
Examples
The following examples illustrate the output from the show network commands on company
Mycompany’s call control system in San Jose with remote voice-mail provided by six remote Cisco
Unity Express sites.
Step 11
end
Example:
se-10-0-0-0(config-location)# end
Exits location configuration mode.
Step 12
network local location id number
Example:
se-10-0-0-0(config)# network local location id 1
Enables networking for the local Cisco Unity Express
system identified by the location ID number.
• To delete the local location, use the no form of this
command.
Caution If you delete the local network location and
then save your configuration, when you reload
Cisco
Unity Express, the local network location
will remain disabled. After Cisco Unity
Express restarts, reenter the network local
location id command to reenable networking at
this location.
Step 13
exit
Example:
se-10-0-0-0(config)# exit
Exits configuration mode.
Step 14
show network locations
Example:
se-10-0-0-0# show network locations
(Optional) Displays the location ID, name, abbreviation,
and domain name for each configured Cisco Unity
Express location.
Step 15
show network detail location id number
Example:
se-10-0-0-0# show network detail location id 9
(Optional) Displays network information for the specified
location ID, including the number of messages sent and
received.
Step 16
show network detail local
Example:
se-10-0-0-0# show network detail local
(Optional) Displays network information for the local
Cisco Unity Express location, including the number of
messages sent and received.
Step 17
show network queues
Example:
se-10-0-0-0# show network queues
(Optional) Displays information about messages in the
outgoing queue that are to be sent from this
Cisco Unity Express system. The queue information
contains three displays: one for urgent job queue
information, one for normal job queue information, and
one for running job information.
Command or Action Purpose