Specifications

3-3
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 3 Entering and Exiting the Command Environment
Exiting the Command Environment
Exiting the Command Environment
To leave the Cisco Unity Express command environment and return to the router command environment,
return to Cisco Unity Express EXEC mode and enter the exit command twice.
The following example illustrates the exit procedure:
se-10-0-0-0# exit
se-10-0-0-0> exit
router#
service-module integrated-service-engine
slot/unit session
Example:
Router(config)# service-module
integrated-service-engine 2/0 session
Enters the Cisco Unity Express command environment
on the NME-CUE.
If the message
“
Trying ip-address slot/port ...
Connection refused by remote host
appears, enter the command
service-module integrated-service-engine
slot/port session clear
and retry this step
service-module service-engine slot/unit session
Example:
Router(config)# service-module service-engine
1/0 session
Enters the Cisco Unity Express command environment
on the NM-CUE-EC, NM-CUE, or AIM-CUE.
If the message
“
Trying ip-address slot/port ...
Connection refused by remote host
appears, enter the command
service-module service-engine slot/port session
clear
and retry this step.
service-module internal-service-module slot/unit
session
Example:
Router(config)# service-module
internal-service-module 0/1
Enters the Cisco Unity Express command environment
on the AIM2-CUE.
If the message
“
Trying ip-address slot/port ...
Connection refused by remote host
appears, enter the command
service-module intern al-service-module slot/port
session clear
and retry this step
Step 5
enable
Example:
se-10-0-0-0# enable
(Optional) Enters Cisco Unity Express EXEC mode. You
are ready to begin the configuration tasks.
Command or Action Purpose